Touchless switch and dimmer for installation in an aluminum profile
Supply voltage:
12-24 V DC /constant voltage e.g. from a LED lamp power supply/
Output voltage:
12-24 V DC with PWM pulse width modulation
State after power failure:
off
Maximum power of controlled lamps:
60 W
Maximum current output:
5 A
Type of sensor:
Motion detection (move). The sensitivity range of the sensor is a few cm from the spring placed between the printed circuit board (PCB) and the cover of the profile.
Operating temperature:
between -10°C and + 40°C
Main design features:
The device takes the form of a printed circuit board (PCB) measuring 10x80mm, allowing it to be placed in an aluminum profile between the LED strip and the power supply. The board has a contact area allowing for the soldering of connection wires.
Safety class:
Class III
Declarations:
RoHS, CE
Warranty:
2 years
The device is designed for touchless switching on and off. It can be used in an aluminum profile covered with a cover. The switchis invisiblefrom the outside of the housing.
Principle of operation:
Bringing a hand close within a few cm of the sensor causes it to switch states on/off. Holding the hand longer will cause dimming or changing the LED light. The operation and readiness of the device is indicated by a white LED.
