Switch for embedding in an aluminum profile with LED tape
Supply voltage:
12/24V DC /constant voltage e.g. from LED lamp power supply/
Output voltage:
12/24V DC
State after power failure:
off
Maximum power of controlled lamps:
60W for 12V, 100W for 24V
Maximum output current:
5 A
Type of sensor:
Capacitive.The sensor's sensitivity field is a few cm from the spring placed between the printed circuit board (PCB) and the profile cover. We ensure effectiveness for LED power supplies without grounding - that is, in protection class II or III.
Operating temperature:
between -10°C and + 40°C
Main design features:
The touchless switch takes the form of a printed circuit board (PCB) withdimensions of 8x54mmallowing placement in the aluminum profile between the LED tape and the power supply. The soldered spring, a few cm high, should be covered by the profile cover and serves as the point of maximum sensitivity of the system. The board has a contact area allowing for the soldering of connection wires.
Safety class:
Class III
Declarations:
RoHS, CE
Warranty:
2 years
The device is intended for turning LED lighting on and off. It can be used in an aluminum profile covered by a cover. The switch is invisible from the outside of the housing.
Principle of operation:
Bringing a hand close within a few cm of the sensor causes it to switch states on/off.The operation and readiness of the device are indicated by a blue LED.
